Allmand-brothers MAXI LITE II User Manual download pdf (Page 44)

MAXI-LITE II

4-7

3 Connect the light connector from the vehicle harness

to the trailer harness.

Make sure that there is adequate slack in the wiring

harness to prevent binding or disconnection when

turning.

4 Before trailering, check all lights for proper operation.

LIFTING THE LIGHT TOWER

The fully loaded light tower and trailer weighs

approximately 3,500 lbs. (1,588 kg) with four fixtures.

The Maxi-Lite II light tower is equipped with bottom

forklift pockets and a lifting eye for lifting or hoisting.

Forklift blades must be at least 60” in length to lift the

trailer.

WARNING

CONTROL HAZARD

Attach the safety chains properly and securely

between the towing vehicle and trailer before

trailering. Never let the chains drag on the ground

when trailering.

NOTICE

Do not allow excessive harness slack or the wiring

harness can be damaged from scraping the ground.

Four- or seven-pin

trailer light harness

connector

Trailer safety

chains

WARNING

ROLLOVER HAZARD

Before lifting, lower the light tower and shut down

the tower lights and the engine. Refer to “PREPARING

FOR TRAILERING - SHUTDOWN” on page 4-3.

WARNING

CRUSH HAZARDS

Always make sure that the lifting device you are using

is in good condition and is rated for the maximum

capacity of the task to safely lift the light tower trailer.

Always get assistance when using a forklift, crane, or

hoist when loading or unloading.

Only use the lifting eye on the lifting bar to lift or hoist

the unit with a hoist or crane.

Only use shackles or a locking-type hook when lifting.

Do not stand or walk under the unit when lifted. Keep

others away from the unit when lifted.

Only lift one light tower at a time.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 79 80

Comments to this Manuals

No comments

Allmand-brothers MAXI LITE II User Manual Page 44

Comments to this Manuals

Related products and manuals for Equipment Allmand-brothers MAXI LITE II