Allmand-brothers MAXI LITE II User Manual download pdf (Page 39)

4-2

MOVING THE LIGHT TOWER

PREPARING THE LIGHT TOWER FOR

DELIVERY

The MAXI LITE II light tower requires service as well as

proper operation in order to provide the performance

and safety it has been designed for. Never deliver or put

the machine into service with known defects or missing

instructions or decals. Always instruct the customer in

proper operation and safety procedures as described in

this Operator’s Manual. Always provide the manual with

the equipment to ensure proper and safe operation.

CHECKLIST

• Visually inspect the equipment to ensure that all

instructions and decals are in place and are legible.

• Inspect the light tower locking bar latch assembly,

which locks the light tower in the vertical position,

for proper operation.

• Check the hitch assembly and safety chains to make

sure that they are in good condition.

• Check the outriggers and jacks to make sure that

they operate properly.

• Inspect the light assemblies for damage and test for

proper operation.

• Inspect the electrical wiring for signs of damage or

excessive wear.

• Check the ground rod cable and the grounding lug.

Make sure that they are clean, undamaged, and

functional.

• Inspect the tires to ensure that they are in good

condition and are properly inflated.

• Check the engine oil, fuel, engine coolant levels, and

hydraulic fluid levels, if so equipped.

• Check to make sure that this Operator’s Manual, the

Engine Operator’s Manual, and the Generator

Operator’s Manual are with the equipment.

• Install the plug into the Fluid Containment System.

• Inspect the machine physically for damage, and

repair if necessary.

After completing the pre-operation checklist, operate

the tower through a complete operation cycle,

following the operating instructions in the

MAXI LITE II Operator’s Manual.

ALWAYS READ AND UNDERSTAND THE

INSTRUCTIONS FIRST

Before trailering, transporting, or lifting your light

tower, read the chapter on SAFETY on page 2-1.

DANGER

ELECTROCUTION HAZARD

Do not operate the light tower if the insulation on the

electrical cord or other electrical wiring is cut or worn,

or if bare wires are exposed. Repair or replace

damaged wiring before starting the engine.

WARNING

UNSAFE OPERATION HAZARD

Never permit anyone to install or operate the

equipment without proper training.

NOTICE

See the appropriate section in the Engine Operator’s

Manual and the Generator Operator’s Manual for

additional pre-operation checks.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 79 80

Comments to this Manuals

No comments

Allmand-brothers MAXI LITE II User Manual Page 39

Comments to this Manuals

Related products and manuals for Equipment Allmand-brothers MAXI LITE II