Allmand-brothers MAXI LITE II User Manual download pdf (Page 40)

MAXI-LITE II

4-3

BEFORE TRAILERING OR

TRANSPORTING

• Lower the light tower and shut down the tower

lights and the engine. See “PREPARING FOR

TRAILERING - SHUTDOWN” below.

• Visually inspect the trailer and equipment for

damage. Repair or replace any components as

needed, prior to moving the trailer.

• Check the trailer lights for proper operation.

• Inspect the tires to ensure that they are in good

condition and are properly inflated.

• Inspect the trailer springs and undercarriage for

damage or loose parts.

• Check the hitch assembly and safety chains.

• Check the outriggers and jacks to make sure that

they are properly stowed.

• Make sure that the ground rod and cable are

properly stowed.

• Clean any spills from inside the trailer bilge area

around the outside of the trailer that may have

occurred during operation.

• Make sure that all compartment doors are closed

and securely locked.

PREPARING FOR TRAILERING - SHUTDOWN

To prepare the light tower for trailering:

1 With the tower lights off, lower the light tower to the

full DOWN position. Refer to “” on page 3-7.

2 Turn the engine off. Refer to your Engine Operator’s

Manual for stopping procedure.

3 Adjust the light bar and light fixtures for trailering;

see “PREPARING FOR TRAILERING - STOWING THE

TOWER LIGHTS” below.

4 Secure the light cords into the hook on the rear mast

support.

5 Disconnect the ground rod cable from the ground

lug.

6 Remove the ground rod from the earth and clean and

secure the ground rod and cable in the trailer.

7 Close, secure, and lock all compartment doors.

8 Raise all five stabilizer jacks and rotate into trailering

position (parallel with the outrigger bar).

9 Retract all four outrigger bars and secure them in the

stowed position with the latch pin.

NOTICE

See appropriate section of the Engine Operators

Manual and Generator Operator’s Manual for

additional post-operation and shutdown procedures.

NOTICE

Visually inspect the light mounting brackets and

hardware for loose fasteners or damaged brackets.

Repair any problems before trailering.

NOTICE

Before transporting, be sure that each outrigger jack

is securely latched in the transport position by

installing the outrigger lock pins.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 79 80

Comments to this Manuals

No comments

Allmand-brothers MAXI LITE II User Manual Page 40

Comments to this Manuals

Related products and manuals for Equipment Allmand-brothers MAXI LITE II