Allmand-brothers MAXI LITE II User Manual download pdf (Page 37)

3-12

USING THE LIGHT TOWER

AUXILIARY AC OUTLET OPERATION

Depending on your model options, the 240VAC single

phase rear outlet panel is equipped with four

240/208VAC outlets and two 120VAC GFCI outlets.

These can be used for powering accessories.

The 240VAC outlet is protected by a 30A circuit breaker.

The 120VAC GFCI outlets are each protected by a 20A

push button-type circuit breaker.

The main circuit breaker is a 90A DPST circuit breaker.

If any of the outlet circuit breakers trip:

1 Remove the load from the outlets.

2 Turn off the tower lights (if they are on).

3 Correct the excessive load problem.

4 Wait 10 minutes to let the generator cool down, then

reconnect the load and resume work.

USING OTHER OPTIONAL EQUIPMENT

SAF-T-VISOR

To install the Saf-T-Visor:

1 Turn off the lights and shut off the engine. Allow the

bulbs and fixtures to cool.

2 Lower the light tower to the full down position.

3 Loosen the lens channel screws to allow the removal

of the lens channel.

4 Remove the silicone gasket and lens.

5 Clean the reflector and lens.

6 Install the silicone gasket and lens (replace if

damaged).

7 Place the Saf-T-Visor in the desired location on the

lamp.

a. If the lamp is in a horizontal orientation, the

Saf-T-Visor can be placed on either the top or

bottom of the lamp.

b. If the lamp is in a vertical orientation, the

Saf-T-Visor can be placed on either the left or right

side of the lamp.

8 Once the Saf-T-Visor is placed on the lamp, install the

lens channel and screws.

a. The outer edge of the Saf-T-Visor should be

positioned between the lens channel and the

silicone gasket.

9 Install the J-hooks and screws on the Saf-T-Visor.

a. The J-hooks should be placed around the lens

channel on the back of the lamp, with the screws

on the front of the lamp (near the lens).

1 Main breaker Turns the whole panel on or off.

2 240/208V

breakers and

outlets

Outlets provide 240V/208V

power. Breakers directly above

turn the outlets on and off.

3 120V GFCI

breakers

Outlets provide 120V power,

protected by GFCI (Ground fault

circuit interrupter). Two reset

buttons are located between the

outlets.

4 Auxiliary

breaker

Turns the 50A outlet on the other

side of the trailer on or off.

MAIN

AUXIILARY

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Comments to this Manuals

No comments

Allmand-brothers MAXI LITE II User Manual Page 37

Comments to this Manuals

Related products and manuals for Equipment Allmand-brothers MAXI LITE II